Guides
A machine's centre of gravity and lifting points
A machine is not lifted just anywhere. The centre of gravity determines how it hangs when lifted and how it is secured on the vehicle; the lifting points determine where a crane or forklift may engage.
What matters
- Centre of gravity
- It is rarely in the middle. For tall machines it is high up, for lathes at the headstock. Many manufacturers mark it on the machine or in the data sheet.
- Crane eyes and transport bores
- They are designed for the machine's weight – not every eye on the housing is a lifting point.
- Fork pockets
- Pockets in the base frame show where forks may be inserted. Fork length and load centre have to match.
- Manufacturer's specifications first
- If there is a transport manual, lifting follows it. Without specifications we clarify the points before the date.
Planning questions
We clarify these points before quoting – the earlier they are known, the more precise the plan.
- Is the centre of gravity marked on the machine or in the data sheet?
- Which crane eyes or transport bores does the machine have?
- Are there fork pockets in the base frame?
- Is a transport manual available?
- Is a spreader beam needed to lift the machine level?
What we need from you
- Photos of the lifting points
- Extract from the transport manual
- Weight and dimensions
- Position of the centre of gravity, if known
Preparation: You hand the machine over ready for transport – dismantling, later installation and commissioning are done by your team or the manufacturer's service.
What we do for you
What we organise
- Transport planned around dimensions, weight and route – with the right vehicle and secure load
- Loading, unloading and crane work organised alongside on request
- One contact who coordinates dates with you and the people on site
Good to know
Manufacturer data or a photo of the lifting points make every lift safer. If they are missing, we clarify it together with you or the manufacturer.
How it works
- 01
Request
You send route, date and machine details using the form below – anything unknown can stay open.
- 02
Review
We check lifting points and centre of gravity and derive lifting equipment, slings and load securing from them.
- 03
Quote
You receive a quote with the agreed scope – on request including loading and crane organisation.
- 04
Execution
Lifting only at the checked points, setting down and securing with the centre of gravity taken into account.
Questions and answers: Centre of gravity and lifting points
Is every eye on the machine a lifting point?
No. Only the crane eyes and transport bores provided by the manufacturer are designed for the machine's weight.
Where do I find my machine's centre of gravity?
It is often marked on the machine or stated in the data sheet or the manufacturer's transport manual.
What if there are no manufacturer specifications?
Then we do not lift on guesswork but clarify the points with you or the manufacturer before the date.
Request
Request for this topic: Centre of gravity and lifting points
Three steps. Anything you do not know yet can be left open.
Details for planning
- Photos of the lifting points
- Extract from the transport manual
- Weight and dimensions
- Position of the centre of gravity, if known